D-link DES-1024D Bedienungsanleitung

D-Link DES-1024D 24-Port 10/100 Ethernet Switch Manual Rev. 080702 Building Networks for People

8 IDENTIFYING EXTERNAL COMPONENTS Front Panel The figure below shows the front panels of the switch. 24-port 10/100Mbps Fast Ethernet Switch LED

9  100Mbps (green) This green LED indicator illuminates when the port is connected to a 100Mbps Fast Ethernet station. The LED does not illuminate

10 TECHNICAL SPECIFICATIONS General Standards IEEE 802.3 10BASE-T Ethernet IEEE 802.3u 100BASE-TX Fast Ethernet Protocol CSMA/CD Data Transfer Rate E

11 TECHNICAL SPECIFICATIONS Performance Transmits Method: Store-and-forward RAM Buffer: 2.5MBits per device Filtering Address Table: 8K entries per

12 WARRANTY AND REGISTRATION Subject to the terms and conditions set forth herein, D-Link Systems, Inc. (“D-Link”) provides this Limited warranty fo

13 for the non-conforming Software will be refunded by D-Link; provided that the non-conforming Software (and all copies thereof) is first returned t

14 other products or services provided by anyone other than D-Link; Products that have been purchased from inventory clearance or liquidation sales

15 as stipulated by the United States Copyright Act of 1976. Contents are subject to change without prior notice. Copyright© 2002 by D-Link Corpo

ii TABLE OF CONTENTS About This Guide ... 1 PURPOSE ...

1 ABOUT THIS GUIDE Congratulations on your purchase of the DES-1024D 24-port 10/100Mbps Fast Ethernet Switch. This device integrates 100Mbps Fast Eth

2 INTRODUCTION This chapter describes the features of the DES-1024D and some background information about Ethernet/Fast Ethernet switching technology

3 Switching Technology Switching is a cost-effective way of increasing the total network capacity available to users on a LAN. If an Ethernet network

4 Switching LAN technology is a marked improvement over the previous generation of network hubs and bridges, which were characterized by higher laten

5 UNPACKING AND SETUP Unpacking Open the shipping cartons of the DES-1024D and carefully unpack its contents. The carton should contain the following

6 included with the device should be attached first, to minimize scratching or scarring of the surface on which the Switch is placed. Attach these cu

7 wiring closet with other equipment. Attach the mounting brackets on each side of the Switch’s front panel (as shown in the illustration below), and