How To Factory Reset The DES-6300 To Default, Add A New IP And
Change Default Password
Please follow the below steps to reset the unit.
Hyperterm: 115200, n, 8, 1,
flowcontrol=none
Once loaded you should see the below (>).
If not hit enter you should now get the (>) sign.
Please see the Blue writing for the commands to type.
>
>debug
Enter DEBUG Password: ********** (dlinkdebug)
DEBUG>erase cdb
After the erase cdb command you should get the below.
**************************************************
***************** SYSTEM RESET *****************
**************************************************
Booting ......
------ Performing the Power-On Self Test (POST) ------
UART Channel Loopback Test........................PASS
Testing the System SDRAM..........................PASS
EPROM Checksum Boot1 Test.........................PASS
EPROM Checksum Boot2 Test.........................PASS
Flash Image Validation Test.......................PASS
Testing CPU PCI Bus Device Configuration..........PASS
BOOT Software Version Prom-0.2.3.0 Built 25-Sep-2002 17:28:32
Processor: MPC8240 Rev 0.13, 200 MHz (Bus: 99MHz), 64MBytes sdram.
I-Cache 16 KB, linesize 32.D-Cache 16 KB, linesize 32.
Cache Enabled.
Autoboot in 2 seconds - press RETURN or Esc to abort and enter prom.
Loading Kernel.
6ff200
100% - Image checksum validated
***************************************************************
*** Running SW Ver. 3.131 Date 03-Oct-2002 Time 10:05:53 ***
***************************************************************
Base Mac address is: 00:05:5d:70:5c:40
Dram size is : 64M bytes
Dram max free block size is : 52M bytes
Dram PTR is : C00000
Flash size is: 16M
Kommentare zu diesen Handbüchern