D-Link DGS-1500-20 Bedienungsanleitung PDF herunterladen (Seite 100)

6 Command Line Interface D-Link Web Smart Switch User Manual

6 Command Line Interface

The D-Link SmartPro Switch allows a computer or terminal to perform some basic monitoring and

configuration tasks by using the Command Line Interface (CLI) via TELNET protocol.

To connect a switch via TELNET:

1. Make sure the network connection between the switch and PC is active.

2. To connect, launch any terminal software like HyperTerminal in Microsoft Windows, or just use the

command prompt by typing the command telnet followed by the switch IP address, eg. telnet 10.90.90.90.

3. The logon prompt will appear.

Logging on to the Command Line Interface:

Enter your User Name and Password to log in. The default user name and password is admin. Note that the

user name and password are case-sensitive. Press Enter in both the Username and Password fields. The

command prompt will appear as shown below (DGS-1500-28>):

DGS-1500-28 login: admin

Password:

DGS-1500-28>

Figure 6.1 – Command Prompt

The user session is automatically terminated if idle for the login timeout period. The default login timeout

period is 5 minutes. To change the login timeout session, please refer to chapter 5.

CLI Commands:

The Basic Switch commands in the Command Line Interface (CLI) are listed (along with the

appropriate parameters) in the following table.

Command Syntax Description of Usage

The ? Displays a list of CLI commands on the device.

download { firmware_fromTFTP |

cfg_fromTFTP} {<ipaddr> |

Download the firmware/configuration from TFTP server to

switch.

upload { firmware_toTFTP |

cfg_toTFTP} {<ipaddr> | <ipv6addr>}

<path_filename>

Upload the firmware or configuration from switch to TFTP

server.

config ipif <ipif_name> [ ipaddress

<ip-address> <subnet-mask> gateway

<gw-address> | dhcp | bootp ]

config ipif <ipif_name> <ipv6

ipv6address <ipv6networkaddr> |

dhcpv6_client <enable | disable>

Configure IP setting of interface.

logout

Logout from this session.

ping <ip_addr>

This command checks if another computer is on the network

and listens for connections.The terminal interface sends five

pings to the target station.

ping6 <ipv6addr>

This command checks if another computer is on the network

and listens for connections.The terminal interface sends five

pings to the target station.

reboot

This command reboots the system. All network connections

are terminated and the boot code executes.

reset config

Reset the device to factory default

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 112 113

Kommentare zu diesen Handbüchern

Keine Kommentare

D-Link DGS-1500-20 Bedienungsanleitung Seite 100

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Netzwerk-Switches D-Link DGS-1500-20