D-Link DPH-80 Betriebsanweisung

DPH-80 IP Phone User’s Guide Version 1.0 Copyright©2003 D-Link Corporation Printed in Taiwan

2. Features • IP address assignment using DHCP (Dynamic Host Configuration Protocol), PPPoE, or static configuration • Silence suppression and com

The DPH-80 implements a sophisticated low-latency adaptive jitter buffer algorithm to combat packet loss and jitter in inter-arrival time of voice t

Right-click on Local Area Connection (LAN). Click on Properties. • In the General Tab, click on Internet Protocol (TCP/IP). • Click on Proper

• Click on Use the following IP address, and enter a value in the 10.1.1.xx range. (Do not use the IP address 10.1.1.80; that address is already

• Make sure Use a proxy server is disabled. • Click OK. 7. Final Configuration The DPH-80 is highly versatile and can be configured to operate

8. MGCP (Media Gateway Control Protocol) 8.1. IP Phone Configuration 8.1.1. Infrastructure Requirements Though the DPH-80 MGCP phone will work in

8.2.1. Login Page to IP phone The following two parameters control access to MGCP phone. Default value for both will be &quo

8.2.2. Configuration Main Page Click on General Configuration. A new page containing information about your system and the DPH-80 will appear. 8

Country Code: This is a drop-down menu. Select the appropriate country. This field controls the type of tones played by MGCP phone. Obtain IP addres

allow the PPP session to be on permanently unless the server closes the connection. This field can be made active later to enable a configuration of

Warranty and Registration Trademarks Copyright  2003 D-Link Corporation. Contents subject to change without prior notice. D-Link is a registered tra

Production Key: This is the key sequence the user should dial on the phone to get to production-test mode. After entering this key sequence, MGCP ph

• Example 2: If the full identifier is given as dlink/1@book. The IP address will not be appended. VAD: When this is enabled, the MGCP phone uses s

8.2.5. RTP Statistics This is an informational page and shows the RTP statistical data from the current call and the previous call. This page is r

On clicking Yes the following screen will appear. 22

8.2.7. Configuration Upload 8.2.8. Configuration Download When clicked, this link will display a warning page. Click ‘yes’ to download the confi

8.2.9. Change Login Name and Password Existing User Name: This is the user name that was used to access the MGCP phone from the web browser. Thi

8.2.10. Save and Restart When clicked, this link will display a warning page. Click ‘yes’ to save all the updated parameters to the flash memory a

8.2.12. Logout When clicked, the You have been successfully logged out page is displayed and the current configuration session is terminated. Note:

• Call progress tone • Ring back tone • Busy tone • Call alert (ringing) tone • Error tone • DTMF tones for all numeric keys • Call Waiting T

Remote diagnosis: The MGCP phone will send status and other messages to the log server configured in the MGCP phone. The remote log server should ru

Any package returned to D-Link without an RMA number will be rejected and shipped back to Purchaser at Purchaser's expense, and D-Link reserves

MGCP phone will play the call-progress tone while trying to establish a call and this can take time. If it takes a long time, check to make sure the

Entered remote-upgrade key sequence, no response You need to have the software files in TFTP server and the MGCP phone should be configured with the

9. DPH-80 SIP (Session Initiation Protocol) 9.1. IP Phone Configuration 9.1.1. Infrastructure Requirements Though the DPH-80 SIP phone will work i

9.2.1. Login page to IP phone The following two parameters control access to the SIP phone. Default value for both will be "dlink". T

9.3. Configuration Main Page Click on General Configuration. A new page containing information about your system and the DPH-80 will appear. 9.3.

PPP passwo d: This is the password used for PPP authentication with the PPP server while obtaining an IP address via PPPoE. rIdle Timeout: This is

Upload Filename (up to 6 characters): This is the filename to upload the configuration parameters from the phone to the TFTP server. It may be 6 cha

9.4. SIP Configuration User Name: The user name is used to identify the caller for display purposes only. It should be maximum 20 characters and s

Outbound Proxy Address: This is the IP address where SIP messages will be sent. This is useful in traversing a firewall. Normally it should be same

9.4.1. RTP Statistics This is an informational page and shows the RTP statistical data from the current call and the previous call. This page is re

LIMITATION OF WARRANTIES IF THE D-LINK PRODUCT DOES NOT OPERATE AS WARRANTED ABOVE, THE CUSTOMER'S SOLE REMEDY SHALL BE, AT D-LINK'S OPTIO

You will be returned to the previous page. 9.4.3. Configuration Upload 39

When clicked, this link will display a warning page. Click ‘yes’ to upload the configuration parameters from the phone to the TFTP server as the

Existing User Name: This is the user name that was used to access the MGCP phone from the web browser. This is case-insensitive and may be 20 charac

9.4.7. Factory Reset When clicked, this link will display a warning page. Click ‘yes’ to reset the phone to factory defaults and automatically res

having an active session with the server, any other user accessing the MGCP phone's configuration will get the Server Busy page and will not be

• SPEAKER: One-touch dialing key. When pressed, speaker LED is on and speaker itself is on while on-hook. If the user off-hooks after dialing or pr

9.6.2. Power up No tone on power up Check the power adaptor and power source, and restart the phone. No dial tone on power up The SIP phone takes t

Browser displays server-busy message It implies that another person is configuring the SIP phone. Browser displays logout message Check the user n

10. DPH-80 H.323 Protocol 10.1. IP Phone Configuration 10.1.1. Infrastructure Requirements This section describes the infrastructure requiremen

Save these parameters after modification from the browser. These parameters will be saved to flash and the H.323 phone will restart with new paramet

The device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful inter

Password: is case-insensitive with a maximum of 20 characters. After logging in, the D-Link DPH-80 Phone Configuration page is displayed and this

PPP passwo d: This is the password used for PPP authentication with the PPP server while obtaining an IP address via PPPoE. rIdle Timeout: This i

Download Filename (up to 6 characters): This is the filename to download the configuration parameters from the TFTP server to the phone. It may be 6

10.3.2. H.323 Parameters Gatekeeper registration: Enable and disable option for Gatekeeper registration. Gatekeeper IP address: IP address of the

10.3.3. RTP Statistics This is an informational page and shows the RTP statistical data from the current call and the previous call. This page is

On clicking Yes the following screen will appear. You will be returned to the previous page. 54

10.3.5. Configuration Upload When clicked, this link will display a warning page. Click ‘yes’ to upload the configuration parameters from the phone

10.3.7. Change Login Name and Password Existing User Name: This is the user name that was used to access the H.323 phone from the web browser. Th

10.3.8. Save and Restart When clicked, this link will display a warning page. Click ‘yes’ to save all the updated parameters to the flash memory a

10.3.10. Logout When clicked, the You have been successfully logged out page is displayed and the current configuration session is terminated. Not

Table of Contents Warranty and Registration ___________________________________________________________ 1 1. Introduction ________________________

• Dial tone • Call progress tone • Ring back tone • Busy tone • Call alert (ringing) tone • Error tone • DTMF tones for all numeric keys 10.4

D-Link to receive and display these messages. This feature can be disabled through the browser. Restore facto y defaults: If you enter the specified

The called party may not be registered with the Gate Keeper (GK). Plays error tone after long time The Gate Keeper (GK) may not be running and the

Power out during remote upgrade If anything goes wrong during software upgrade the phone will use the previous existing software.

11. DPH80 New Firmware Download Procedure From time to time, the DPH-80 will upgrade the software (firmware) that operates the IP Phone. Firmware

11.3. Downloading • When you receive a new release verify the files as mentioned previously in Section 2. Release. For changing the file names refe

12. Configuration Upload and Download This document aims at helping the user to upload and download configuration parameters from DPH80 system. 12.

12.2.1. Download configuration The DPH80 system must be configured with the system IP address and filename of the new configuration parameters. This

13. SIP and H.323 Phone Book The Phone book feature of the DPH80 emulates the point-to-point functionality of the VOIP protocols. 13.1. SIP phon

Using the phone book feature, the user can make and receive calls to and from other H.323 endpoints without the H.323 gatekeeper or soft switch. Reg

9.1.1. Infrastructure Requirements ______________________________________________ 31 9.2. Configuring the SIP phone_______________________________

Offices Australia D-Link Australia 1 Giffnock Avenue, North Ryde, NSW 2113, Sydney, Australia TEL: 61-2-8899-1800 FAX: 61-2-8899-1868 TOLL F

Germany D-Link Central Europe (D-Link Deutschland GmbH) Schwalbacher Strasse 74, D-65760 Eschborn, Germany TEL: 49-6196-77990 FAX: 49-6196-779

Taiwan D-Link Taiwan 2F, No. 119 Pao-chung Road, Hsin-tien, Taipei, Taiwan TEL: 886-2-2910-2626 FAX: 886-2-2910-1515 URL: www.dlinktw.com.tw

Registration Card Print, type or use block letters. Your name: Mr./Ms ____________________________________________________________________________

73

10.6. H.323 Troubleshooting ___________________________________________________ 60 10.6.1. Power up ______________________________________________

1. Introduction The D-Link DPH-80 is a fully featured Ethernet business phone that allows both business and residential customers to benefit from I