D-Link DWC-1000 Bedienungsanleitung PDF herunterladen (Seite 68)

Wireless Controller User Manual

Figure 38: Managed AP status

MAC Address: The Ethernet address of the controller-managed AP.

IP Address: The network IP address of the managed AP.

Age: Time since last communication between the Controller and the AP.

Status The current managed state of the AP. The possible values are:

• Discovered: The AP is discovered and by the controller, but is not yet

authenticated.

• Authenticated: The AP has been validated and authenticated (if authentication

is enabled), but it is not configured.

• Managed: The AP profile configuration has been applied to the AP and it's

operating in managed mode.

Failed: The Controller lost contact with the AP, a failed entry will remain in the

managed AP database unless you remove it. Note that a managed AP will

temporarily show a failed status during a reset.

Profile: The AP profile configuration currently applied to the managed AP. The

profile is assigned to the AP in the valid AP database.

Radio Interface: Shows the wireless radio mode that each radio on the AP is

using.

This page includes the following buttons:

• Delete—Manually clear existing APs

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 180 181

Keine Kommentare

D-Link DWC-1000 Bedienungsanleitung Seite 68