
DES-7200 Hardware Installation Guide
2-4
2.1.5 Laser Safety
Among the modules supported by the DES-7210/7206, there are a great number of optical
modules that are Class I laser products. Therefore, pay attention to the following during your
use of this product:
When a fiber transceiver works, ensure that the port has been connected with an optical
fiber or is covered with a dust cap, to keep out dust and avoid burning your eyes.
Do not stare into any optical port.
Danger
Do not s tare into any optical por t u nder a ny c ircumstances, as this m ay
cause permanent damage to your eyes.
2.2 Installation Site Requirements
The DES-7210/7206 must be used indoors. To ensure the normal working and a prolonged
useful file of the equipment, the installation site must meet the following requirements.
2.2.1 Requirements for Rack Mounting
If you plan to mount the DES-7210/7206 in a frame, you must verify that the frame meets the
following conditions:
Install the switch in an open cabinet as much as possible. If you install the switch inside
a closed cabinet, please make sure that the cabinet has a good ventilation an d heat
dissipation system.
Make sure that the cabinet is firm enough to bear the weight of the DES-7210/7206 and
its installation accessories.
Make sure that the dimensions of the cabinet spare certain space for the installation of
the front, rear, left and right panels of the DES-7210/7206 for the sake of heat
dissipation.
The frame should be properly grounded.
2.2.2 Ventilation Requirements
Figure 2 -3 an d F igure 2-4 s how t he v entilation r equirements of t he DES-7210/7206. Yo u
must ens ure that s ufficient s pacing is r eserved at t he ventilation op enings to ensure t he
normal w orking of v entilation. After v arious c ables h ave be en c onnected, t hey s hould b e
arranged into bundles or placed on the cabling rack, to avoid blocking the air inlets.
Kommentare zu diesen Handbüchern