D-Link DCS-2100+ Bedienungsanleitung PDF herunterladen (Seite 104)

104

DCS-2100 User’s Manual

D-Link Systems, Inc.

Using IP Surveillance Software

Marking/Unmarking the Recording Time on the Hour Time-Line

You can apply the one-click function by clicking the left mouse button and dragging to

mark the time on this time-line. The operating method for the hour time-line is the same

as that of the week time-lines. Please refer to the previous section about marking/

unmarking on the week time-line for more details.

Schedule with Time Picker

Begin and End Time

There are three controlling units in both “Begin Time” and “End Time” selectors shown

below. The first unit of these two selectors is the date picker. You can select day with it to

set the beginning time and the ending time for the recording interval.

The second and third units are the hour picker and the minute picker. You can change

the hour and minute settings for the beginning and ending time with them.

Note: The time set in “Begin time” must be earlier than that in “End time”. Otherwise the

settings will not be applied.

Apply and Erase Buttons

After you have selected the time period with “Begin time” and “End time” picker, you can

apply the period picker, shown in the figure below, to set the periodical types of the time

interval set previously. After the settings in “Begin Time”, “End Time” and “Period Picker”

are all done, you should click the “Apply” button or “Erase” button on the right to add or

clear this scheduling information to the editing schedule scheme. Note that only after

you click on the “Apply” button, the scheduling information settings will be written back

into the whole editing schedule scheme. That means this edited scheduling time interval

is valid only after you “Apply” the changes.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 137 138

Keine Kommentare

D-Link DCS-2100+ Bedienungsanleitung Seite 104