D-Link DSA-3200 Bedienungsanleitung PDF herunterladen (Seite 31)

IDENTIFICATION VARIABLES

VARIABLE E C H O

VALID VALUES 0 or 1

DEFAULT VALUE 0

DATA TYPE integer

DESCRIPTION Determines if characters received from a serial host will be echoed back to

the host.

0 - the DSA will not echo characters

1 - the DSA will echo characters back to the host.

VARIABLE MODEL

VALID VALUES 3207, 3217, or 3218

DEFAULT VALUE 3217

DATA TYPE string

DESCRIPTION Determines the module type. When set to 3207, special variables are

enabled to permit up to eight(8) ranges in a module. The recommended

setting of ZC depends on the setting of MODEL. Please refer to the

description of ZC for mor einformation.

VARIABLE PORT xxxx

VALID VALUES Any valid port number other than 0

DEFAULT VALUE 23

DATA TYPE integer

DESCRIPTION Sets the Ethernet port. The default value is 23 which is the TelNet port. A

change to this variable does not take effect until the module has been

rebooted. If PORT is set to zero, communications in Ethernet will be

impossible.

VARIABLE HOST <IP Address> <Port> <Protocol>

VALID VALUES IP Address - Any valid IP Address

Port - Any valid port number other than 0

Protocol - U for UDP

T for TCP

DEFAULT VALUE IP Address - 0

Port - 0

Protocol - T

DATA TYPE Varies

DESCRIPTION Sets the parameters for binary transmission to a host com puter. The default

port value is 23 which is the TelNet port. For binary transmission to

Scanivalve Corp BTEL program , protocol must be set to U. A change to this

variable does not take effect until the module has been rebooted. If PORT

is set to zero, communications in Ethernet will be impossible.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 51 52

Keine Kommentare

D-Link DSA-3200 Bedienungsanleitung Seite 31