D-Link DSA-3200 Bedienungsanleitung PDF herunterladen (Seite 38)

DSA3200 Boot Parameter Modification

The DSA3200 Series modules use an operating system licensed from VxW orks. The boot parameters are

set at the factory, but these parameters may be modified to suit the needs of a specific installation. This

section documents the modification of the boot parameters.

1. De-energize the DSA3200. Connect the DSA3200 trigger/serial test cable (Scanco part

#155829) from the DSA3200 to a host PC.

2. Start HyperTerminal, or an equivalent communication program. Connect the DSA3200 to

a COM port on the PC Host. Set the serial parameters to 9600 BAUD, no parity, 8 data bits

and 1 stop bit.

3. Energize the DSA3200. The following sign-on information should be displayed.

VxWorks System Boot

CPU: HITACHI hs7709

Version: 5.3.1

BSP version: 1.1/0

Creation date: Feb 9 2000, 12:41:05

Press any key to stop auto-boot...

4. Press any key within 3 seconds to stop the auto-boot process. If a key is not pressed within

the 3 seconds time, the system will proceed to auto-boot with the existing operating system

using the current setup.

NOTE: The boot-loader will continue to reboot until stopped by pressing a key under the

following conditions:

A. If boot-from-flash is selected, and no operating system is present

in flash.

B. if boot-from-net is selected and the FTP server is not correctly set

up.

5. W hen the auto-boot process is stopped, the boot-loader will prompt with:

[VxW orks Boot]:

To get a list of the existing boot parameters:

Type: p <Enter>

The following list is the default setup:

boot device : cs

processor number : 0

host name : host

file name : c:/dsa_hs/vxworks.st

inet on ethernet (e) : 191.30.80.100

host inet (h) : 191.30.101.109

user (u) : DSA_HS

ftp password (pw) : scanivalve

flags (f) : 0x0

other (o) : flash,000.096.093.218.000.002,10baset

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 51 52

Keine Kommentare

D-Link DSA-3200 Bedienungsanleitung Seite 38